900mm Camera Slider Remixed from Adafuit’s 500 mm one.

I remixed Adafruit’s models to use a 900 mm rail instead of dinky short 500 mm one.

I plan on using this camera slider to recode videos of my 3d printed models.

Link to my Remix: http://www.thingiverse.com/thing:2182544

Link to AdaFruit’s Version: http://www.thingiverse.com/thing:1041408

Links to Amazon products:

900 mm Rail 

AA battery case

Adafruit BlueFruit SPI

Motor Shield for Arduino

608ZZ 8x22x7 ball Bearings

Arduino Uno R3

5 metters of 6mm GT2 Timing belt

Assembly Instructions can be found on AdaFruit’s Website:


Make sure you tighten the belt and some grease around the pulley and along the rails

Code is still in progress:

I am writing my code to move to the center of the rail then slide off after a full revolution of my turn table.


Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s